How do I remove this cover I have to replace the power button?
Wayne for Model Number lhw0050pq4
Answer Hello Wayne. 1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Pull the washer away from the wall so you
can access the rear of the unit.
4. Remove the two screws from the back of
the top cover. 5. Lift the rear of the top cover, unhook it from
the front, and remove the cover. 6. To remove the power on/off switch:
a) Grasp the pushbutton with your fingers
and pull it off the power on/off switch
shaft.
b) Using a small-bladed screwdriver,
press the two locking tabs on the sides
of the switch toward the switch body,
and pull the switch out of the mounting
location on the control panel. c) Disconnect the two brown and two
blue wires from the power on/off switch
terminals. 7. To remove the spin speed or wash
selector switch:
a) Pull the knob off the switch shaft.
b) Remove the two screws from the component
cover and remove the cover. c) Lift the locking tab on the selector
switch board connector, and pull the
connector off the switch board.
d) Remove the two mounting screws from
the selector switch and remove the
switch from the control panel. 8. To remove the LED board:
a) Remove the component cover (see
step 7).
b) Remove the two mounting screws from
the LED board and remove the board
from the control panel. c) Pull the ribbon cable connector off the
board connector and remove the board. 9. To remove the pushbutton board:
a) Remove the component cover (see
step 7).
b) Remove the four mounting screws from
the pushbutton board. c) Remove the board, board seal & holder,
and pushbuttons from the control panel.
d) Pull the two ribbon cable connectors
off the board connectors and remove
the board.