What is the shipment fee?
Answer Nancy, please see the following link to view our available shipping options. Thanks! http://www.appliancepartspros.com/customerservice/shipping.aspx
My dryer will not come on the light on the inside of the dryer works but the control panel will not come on.
Answer Hello Daniel. Test the thermal fuse. If good, test for power to the control board. If there is power there, and it does not work, you will need to replace the control board 8558756. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
How do you remove the part#4 panel-cntl from the dryer without breaking it.
Answer Peter, Here you go : 1. Turn off the gas to the dryer and disconnect the electrical power. 2. Pull the dryer away from the wall and remove the top cover.Remove the three hex-head screws from the rear flange of the dryer’s top cover. NOTE: The top cover screws have nylon flat washers on them. Be sure to use these screws when you reinstall the top cover NOTE: Sharp edges may be present. 4. Lift the rear of the top cover and slide it back so the tabs clear the catches on the bracket, and remove the cover from the unit. NOTE: Make sure that the tabs slide under the bracket catches when you reinstall the top cover. 5. Remove the three screws from the machine
control electronics board bracket and pull the bracket away from the side of the dryer so you can access the connectors. 4. Disconnect the ends of the two ribbon cables from the machine control electronics board connectors P3 and P4. 5. Remove the two screws from the console bracket. 6. Open the door and pull out on the bottom of the console to release the locking tabs from the door panel. 7. Lift the console straight up until the brackets are free of the left and right side panel flanges and remove the console. 8. Place the console assembly on a padded work surface with the bracket side facing up. 9. Remove the four hex-head screws from the console bracket and remove the bracket. 10. Remove the selector knob. 11. Remove the touchpad subassembly from the console by unsnapping the six atches.
Use your thumb or a screwdriver. This ought to get you through the repair. Good Luck and Thanks