How is this panel attached to the dryer / removed from the dryer?
Answer Hello Charlie. 1. Unplug dryer or disconnect power.
2. Turn off gas supply to dryer (some models).
3. Pull the dryer away from the wall and
remove the top cover. 4. Remove the three screws from the electronic
control board bracket, and tip the
bracket assembly inside the dryer. 5. Disconnect the ends of the two ribbon
cables from the electronic control board
connectors P3 and P4. 6. Remove the two screws from the console
bracket. 7. Open the door and pull out on the bottom
of the console to release the locking tabs
from the door panel. 8. Lift the console straight up until the brackets
are free of the left and right side panel
flanges and remove the console W10099610.