Can you give me a step by step to remove and replace the control panel? My current panel is working fine but the plastic broke out around the door latch and left a gaping place where the latch snaps down when locked. I guess I have to replace the whole panel? If so I can order in bisque but would like to consider steps to replace. I have already once replaced the door latch so I am acquainted with the loosening of the back panel. What is involved in connecting the various controls of the panel electrically? Is is as simple as the door latch was? Guidance will be appreciated.
Answer David, Here you go. " Control Panel The Membrane/Facia on the Control Console is not replaceable. Removal 1. Disconnect power to the machine.2. Remove the Inner Door Panel. (See paragraph Inner Door Panel removal).3. Remove PC Board Housing Cover. 4. Disconnect Membrane Switch from PC Board. 5. Remove PC Board Base.6. Lift out Latch Assembly. 7. Remove 4 screws securing Control Panel to Outer
Door. NOTE: Facia is susceptible to damage during reinstallation. Inner Door Panel Removal of the Inner Door Panel will allow access to the
Microprocessor Board, Door Switches, Detergent / Rinse Aid Dispenser, and Vent Assembly. Removal 1. Disconnect power to the machine.
2. Open the Dishwasher door. 3. Remove the 11 Torx™ screws along the sides and top of the Inner Door Panel. 4. Separate the Inner Door Panel from the Outer Door. 5. Disconnect wires from the Vent and Dispenser Wax Motors before pulling the Inner Door Panel away
from the Dishwasher. PC Board Removal 1. Disconnect power to the machine. 2. Remove the Inner Door Panel. (See paragraph Inner
Door Panel removal).3. To access PC Board, remove 1/4" screw on PC Board Housing Cover. 4. To remove PC Board, loosen (2) 1/4" screws
securing PC Board Base to Control Panel. 5. Remove pin and ribbon connectors from PC Board. 6. Depress tabs on PC Board Housing to remove PC Board." Thanks and Good Luck