I need to replace control panel in dishwasher. Is this a difficult process? I am very handy and mechanical
Answer Hello Carolyn. No, it is not hard to replace the control panel on the unit. You will need to disconnect the power to the unit. Then remove the screws securing the inner door panel. Remove the inner door panel and remove the cover off the control board. Remove the ribbon cable from the control board and remove the screws holding the control board housing in place. Next remove the screws holding the control panel in place. Reinstall with the new control panel in reverse order.
My Maytag dishwasher Start button does function anymore and the washer will not run. Is this the front panel or circuit board/wiring issue?
Answer Hello Jeff. Make sure the door switches are good. If so, and the button doe not work, you will need to replace the control panel on the unit.
Hi, we have the Amana ADB3500AWW dishwasher. It is stuck in Auto Wash Mode. Start/Cancel seems to be the only button that works. I'm wondering if this is typically a control board problem or a keypad problem? Also, two control boards that look about the same are listed for this model, which is the right one?
Answer Hello Scott,
You would want to check to make sure that the key is not stuck. Disconnect power to unit for approximately 30 minutes to allow to reset. Upon reconnecting power if the unit continues to only have auto wash on then you would need to replace the membrane switch 6-919805. As far as the control boards go the reason for the different part numbers is due to series change. If the first 2 digits of the serial number are before 33 then you would use control board part number 12002709 If it has 33 or higher then part number W10218825 is the control board you would need.