Panl-Cntrl

Ed V for Model Number Mew5530ddb

Answer Hello Ed, You will want to check to see if you are getting power to the light and bake element. If you check for voltage on the control board from connector p15 pin 2 to connector P2 pin 3 you should have 120vac. If you do not then you have a bad control. If you do then check bulb. Also check from connector P4 from bake to L1 pins 1 to 4 for 240 vac. If not correct voltage replace control board if correct then check wiring and element. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Valerie for Model Number MEW553oDDB

Answer Hello Valerie. Based on the information you provided, you will need to replace the control panel in the unit. Also, make sure you are not using cleaner on the control panel. It can damage the panel. When cleaning the outside of the unit. Use a damp soapy cloth to clean and then wipe off with a damp cloth. 

John A for Model Number Maytag model # mmw5530dab

Answer Hello John. To repair the unit, you will need to replace both the door lock W10186996 and the control board 74008960 on the unit. 

Alan W. for Model Number Maytag MEW5530DDB

Answer Hi Alan. Are there any cracks in the face of the control buttons ? If you can see the clock and have this issue then you need to replace the control panel assy. part # 5765M432-60. Thank You. 

Bruce R. for Model Number MAYTAG Oven MEW5530DDB

Answer Hello Bruce. 12001656 is the temperature sensor. You should read 1650 ohms at 350°. If it is off by 100 ohms, replace the sensor. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Thomas Y. for Model Number MMW5530DAB

Answer Hello Thomas. Here is what you will need to do. 1. Turn off power to unit. 2. Remove screws securing trim piece(s) to the cabinet. 3. Slide unit out of cutout approximately 6 to 8 inches. 4. Remove screws securing control panel assembly to unit chassis. 5. Label and disconnect wire terminal plugs from control board assembly. 6. Place control panel assembly on a protected surface. 7. Reverse procedure to reassemble. Hope this helps.