Whirlpool 34001484 Pcb (mems) Sensor - AppliancePartsPros.com

Total
$0.00

Part Number:	AP4044365
MFG Part Number:	34001484
Made by:	Whirlpool

Our Price
$80.20
Regularly	You Save
~~$94.64~~	$14.44

Most Interesting

I did the check for motor failure and the OHMS on all points was 11.3, you say it's supposed to read 11.6, Does this mean my motor is bad?

Gw for Model Number MAH9700AWW

Answer Hello GW. No, that is a good reading on the motor. It sounds like the board may be the issue with the unit.

Was this helpful?

On the spin cycle is shows the error code 3E but it does not do it every time. It does it maybe 3 out of 5 times, can you help me with this?

Gw for Model Number MAH9700AWWMAYTAG

Answer GW, The 3E indicates a motor failure (Over current). This means that over current is detected and the motor won't turn. You will want to check the motor windings, the speed sensor, wiring connections and control board. The tech sheet that is located in the unit will tell you how to check. Any 2 pins on the motor connector should read 11.6 ohms. Pin 1 to 2, pin 2 to 3 and pin 1 to 3 on the CN9 connector of the main control should read 11.6 ohms. If outside the range then the motor is bad.

Was this helpful?

I keep getting error code E3 what does this mean

Answer GW, To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx

Was this helpful?

Latest Questions

I'm getting a E2 error on the display and washer will not operate at all. the machine stopped with the basket full of water. What does this code mean?

Chuck for Model Number nfw7200tw

Answer Chuck, The error code E2 indicates that there is a stuck key on the control. You will want to unplug unit for 30 minutes. Plug back and if the code returns then you will need to replace the keypad.

Was this helpful?

my washing machine goes through the wash cycle, and stops at rinse and spin the pump does not kick on for it to drain. I have taken the pump off and wired it direct and it works fine, i also checked all lines and tub for blockage. I also check the voltage in the wire coming in pump from control board and it is 118 V. I but machine doesn't drain and error comes is "nd". is it pump/control board or reactor?

Danish H for Model Number IFW7200TW

Answer Hello Danish, If you are getting proper voltage to the drain pump it may be that the vanes on the impeller are bad and you would need a new pump.

Was this helpful?

Everything in the machine is fine until it has to drain. Then we have to pump the water out and the washer works fine. And then it moves on to the next cycle. We checked the pump and its working but the output from the control board is 120 v but the pump only gets 20 v. What could be the problem? could it be the MEMS sensor or door switch?

Witold for Model Number mah6700aww S#15077558le

Answer Hello Witold, If you are only getting 20 vac to the pump then you need to check the wiring. To go from 120 vac from control board and only have 20 vac then you would have a shorted wire, loose or broken connection somewhere in the wire harness and will have to trace the wire to find it.

Was this helpful?

Pcb (mems) Sensor

Questions & Answers

Appliance Compatibility Tool

Repair Help

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information