I HEAR A SQUEEKING NOISE COMING FROM UNDERNEATH THE WASHER. COULD IT BE THE PULLEY THAT THE BELT IS ON. IF SO I NEED THE PULLEY AND THE BELT.
Tracy for Model Number LAT5916AAE
Answer Tracy, It's not likely you'll need the pulleys, They both, can be cleaned, using som,e fine sandpaaper or emory cloth. But you should be repalcing the belts 12112425, and lubricate the motor carriage rollers 205000 with a liberal coating of "vaseline". Thanks and Good Luck
Washer empties but locks up in spin cycle & belt slips. Unsure about disassemble and if cost of the repairs will warrant repairs
Curt O for Model Number LAT2500AAE
Answer Curt, If the washer agitates and drains, but won't spin, theres a 90 % or better chance you have a seized tub bearing. You'd need to remove both tubs and all components inside the tub to replace the tub bearing and tub seal assembly(s) 6-2095720 6-2040130 12112425 and a spanner wrench TJ90TB123A. if that's the case. totest the transmission, raise the front of the washer and block it up, remove the drive belt to the center pulley. Turn the pulley counterclockwise and the agitator should oscilate back and forth. Turn the pulley clockwise and the tub should start to turn/spin in 1/2 to 3/4 of a revolution( you may even hear or feel the bearing "break loose" if you do it right. It usually takes 60 or so minutes for a DIY'r to perform and worth the time and effort(in my opinion). Good Luck and Thanks