Pulley, Spin/agit (710 Rpm)

Bart for Model Number SAV515DAWW

Answer Hello Bart, The transmission will require replacement. If you attempt this repair, you will also require the Outer tub seal and spin bearing. I would include part numbers but the serial numbers' first two digits denote the specific replacement parts. 

Praiman for Model Number sav5910EWW

Answer Hello Praiman. The brakes are slipping. This part number is a kit which includes all three brake pads R0000014. It also includes an instruction sheet. Have a great day! 

George for Model Number NAV8800AWW

Answer Hello George. Make sure the rotor R9900474 is holding the brakes so the unit can agitate. If not, you will need to check/replace the rotor. on the unit. Hope this helps. 

Mike

Answer Hello Mike. You will need to remove the springs and the tub assembly from the unit to remove the pulley 40047102. Hope this helps. 

Mike for Model Number sav4655eww

Answer Hello Mike. You will need to remove the tub assembly from the cabinet and flip the tub over on it's top. Then you will remove the pulley system 40047102 to access and check out the brake assembly. Hope this helps. 

Michael K. for Model Number SAV505DAWW

Answer Hi Michael. Counter clockwise is agitation. Clockwise is spin. Therefore the brakes have to be released by the brake rotor. The rotor is part # R9900474 The brake pads are part # R0000014. Lift up the top. Remove the tub top cover. Is there any clothing jammed in between the inner and outer tub stopping regular operations? Remove the belt. Rotate the motor and the pump to see if they are working in both directions also. Inspect the brakes and see if they are broken and jammed in the clutch sideways. Thank You.