Which direction should the groove in the gasket face, against the lower tub lip, against the upper tub side, or against the clamp ring?
Barkingdog
Answer Barkingdog, When you install the tub cover seal 211232 the groove in the saeal should face UP(so you can see it) then install the clamping ring. A quick note : make sure there is a 3/8 to 5/8 inch gap between the top of the spin tub and the bottom side of the tub cover, the tub can contact the bottom of the cover and not spin. Good Luck and Thanks
I innstalled a new seal , with new bolts on the ring, but find it leaks when draining & spinning. What did I do wrong?
Ralph for Model Number A209
Answer Hi Ralph. You would need to replace the complete ring assembly, part # is 200846. The bolt and the worm cut of the ring wears out with the tightness of the bolt thread "teeth" together . Thank -You.
What thickness spacers between top of inner tub and outer tub top are needed when re-installing top with new seal and clamp ring ?
Guest for Model Number LA210
Answer Hello. There are no spacers need when reinstalling the new seal and clamp. The clearance should be between 9/16 and 5/8 between the top of the spin basket and the under side of the tub cover. Hope this helps.