Sensor

Yancy for Model Number MVWC6ESWW1

Answer Hello Yancy. You will need to order and replace the temp switch W10248240 and the timer W10243947 on the unit to repair the issue. 

Jeremy for Model Number Whirlpool WTW6400ST

Answer Hello Jeremy, You will want to make sure that your pressure hose is fully seated on the control board and make sure that you check it for clogs or breaks in it. This would normally be the case in an overflow issue. 

Dale R for Model Number WTW7320YW0

Answer Hello Dale, You will want to check your recirculation pump. Check to make sure that it is not clogged or something jammed in it. Check the hoses from pump to tub to ensure that there are no clogs. If not then you would need to replace the pump W10233462. 

John for Model Number WTW6700TU1

Answer Hello John, In order to better assist you, we would need to have the error code number. 

Michael for Model Number wtw6700tw1

Answer Hello Michael. The bearings are bad. You will need to order and replace the outer tub assembly W10193886 on the unit. You can replace just the bearings W10435302, but will need to order the tool W10447783 and it is a lot harder repair. 

Jason G for Model Number MAytag MVWB300WQ0

Answer Jason, First check and make sure the top of the drain standpipe is at leasr 38 to 39 inches up from the floor, if it's an inch or two too low, the water will syphon out. If the standpipe is high enough, and the end of the drain hose is not "stuffed" or sealed to the pipe, then you want to check the eleectronic control board W10258402 and air dome tube 353244.