Replaced the exterior oven door glass. Can't figure out how to put the side trim back. Is ther a picture?
Dave for Model Number RF364PXPQ2
Answer Dave, The APP parts diagram, is a pretty good facsimile,but here are the written instructions from the manual " 1. Turn off the electrical supply to the range. 2. Remove the oven door, and position it on a protected floor with the handle and outer door glass facing up.
3. Raise the top of the door and remove the two screws that secure the top of the door trim and the handle to the door liner, then remove the handle and top trim.4. Slide the outer door glass out of the bottom trim channel and install the new glass in its place.
5. Install the top trim and handle on the oven door and secure them in place with their two mounting screws. REASSEMBLY NOTE: The
side trim on Whirlpool oven doors fits under the top edge of the outer door glass, and the side trim on Roper models fits over the top
edge of the glass. Make sure that the trim is seated properly when you tighten the screws. 6. Reinstall the oven door on the range." Another note, if you purchased new side trim rails 8523173 the screw holes in the new trim have been removed and replaced with "dowels" The dowels will be installed in the screw openings in the bottom trim rail 8523178. Thanks and Good Luck
Hello. Just ordered two new trim parts for this ovens door. We took the door apart to clean the glass and while trying to reassemble we broke both of these side trim pieces drats!!!! We must be doing something wrong and I am hoping you can provide me with an instruction info to help us reassemble without braking anything again. Thanks. P.S. That glass is clean !
Carolyn for Model Number rf361pxkq0
Answer Hi Carolyn. The left side trim is part # 8523172. The rt. is part # 8523166. Bottom trim is part # 8523175. The side trim pieces will slide up into the top trim sides (not hanging out on each side). There are no instructions because the "green" movement only gives the service manual with instructions enough to repair the functional operation of the unit. The front glass is placed into the frame on all sides and you screw the bottom trim snug -as the top sides- of the trim is placed into the top trim piece. Then install the top screws and snug the top screws. Install the door handle screws w/ blue loctite part # F8283401. These do not over tighten as it will kink the glass and pull the top back. Outer Glass part # 9762476 white. Thank You.