Tub is unbalanced and leaning towards the front right. Due to this, the spin cycle is constantly stopping. Will the spring kit and damper kit help solve the problem? Is one spring kit enough to replace all the springs? Also, what is the difference between the spring kit and roller kit? Thanks
Answer Matt, You're parts are a little bit off, there is no spring kit for the tub support for this style washer, you probably won't need them anyway. You will want to check and make sure the washer is level and as close to the floor as possible, then remove the front panel and check the base of the washer. Look for the polyester damper pads 203956 to be sticking out from under the damper 203725 and gray colored powder spread about the base. this will indicate a worn out damper and damper pads, and they will need to be replaced. The spring kit 202718 and roller kit 205000 are associated with the motor. these are the parts that maintain the tension on the belts and keeps the motor in proper location for the proper drive. The motor carriage has to move freely and the rollers and carriage need to be cleaned and lubricated or replaced if worn or broken.