Will not start. Lights flashing on door. All conection are good.
Answer Hello John. You will need to test the door switch and see if it is bad. When the door closes, the switches should make up. Test the switch with the power off to the unit. You can test this with a multi-meter TJMA-DM1. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
1 person found this answer helpful.
The "clean " light is flashing and dishwasher will not start.
Answer Hello Philley,
When the clean light flashes it can only mean one of two things. It can mean that a button is stuck and the control panel is in need of replacement or it can mean that the heating circuit has failed. The way to tell which has happened is that if the heating circuit has failed, the clean light will flash seven times with a pause and then flash seven times with a pause, etc. If this is the case, you need to troubleshoot the heating circuit. There are five components: the heating element, the high limit thermostat, the door switch, the control, and the wiring harness.
There should be a tech sheet behind the kick panel which will show the wiring diagram. This should enable you to shoot through the circuit with an ohm meter. If it reads open from the control board, you will need to test each component individually. I have found that if the unit is solidly mounted under the counter top and is properly leveled, the heating element is the most common part to fail.
Normal Mode light blinks. I reset control panel and works for a while then stops and Normal Mode light blinks again?
Answer Hello Richard. Based on the information you provided, you will need to order and replace the control panel 3385741 on the unit.