Whirlpool 99002751 Switch, Door - AppliancePartsPros.com

Total
$0.00

Part Number:	AP4114315
MFG Part Number:	99002751
Made by:	Whirlpool

Our Price
$14.93
Regularly	You Save
~~$17.62~~	$2.69

Most Interesting

Many of the push buttons on the touch panel are dead and won't start the cycles. The ones that come on go off after 20-30 seconds and no cycle will start. I ordered part # ap4009230 control board and I still have the same problem. The door switches have a lot of blue discoloration, but they click. My multimeter is broke so I can't test them. Do you have any recommendations as to what could be the problem?

Jim for Model Number MDBH955AWS

Answer Hello Jim! it seems that you may have a defective control panel 6-920244. The control panel has a ribbon cable that connects and sends signals, when pressed, to the control board. The ribbon cable is only available with the control panel. Hope this helps!

1 person found this answer helpful.

Was this helpful?

The handle on our dishwasher broke. We bought a replacement (W10130696). How do you remove the door switches (99002751)? One of ours broke and we are unable to pull them out? Any advice would be helpful.

Christina for Model Number MDBTT60AWQ

Answer Christina, There is a screw that holds the latch assembly in place. Remove the screw and lift out the latch. With the latch assembly out push on the clip on the back side of the switch to release the switch to pull off.

Was this helpful?

My control panel will not work after installing a latch assembly. The control panel is flashing the letter L. Also the number 3 light indicator stays on.

Richard for Model Number MDBH975AWS

Answer Hello Richard. You will need to check all the wiring connections on the unit. Also, make sure when the latch is closed, it is making contact with the switches in the unit.

Was this helpful?

Latest Questions

When I try to open the door the knob you push under the bar at the top of the door and it will not open the door as it sticks. It appears that the push button goes up into the handle. What part do I need to order to be able to open the door more easily.

Nadine M. for Model Number Maytag Dishwasher Model No. MDB7601AWW

Answer Hello Nadine, This is going to require that the door latch assembly W10130694 be replaced.

Was this helpful?

How many door switches are required for this machine? When looking up the part it does not state if you are buying one or two on the part number and does not tell you how many are required. Thanks for your help, Karen

Karen for Model Number mdbm755a maytag dishwasher

Answer Hello Karen! The door switch 99002751 comes one per package. Your unit uses two door switches. Thanks!

Was this helpful?

i disconnected the door switch and put it back in wrong. now i cant get if pulled back out and my dishwasher fills with water but wont start the cycle. is there a trick to getting the switch pulled out and also a diagram of how it plugs in properly? i did it a while ago and cant even remember which one i pulled out. thanks

Matt for Model Number Jenn-Air JDB1100AWS

Answer Matt, The switches, are locked in place by a plastic clip on the latch assembly. There are also pins on the door that the openings on the switch slip over to proper align the switch. Remember, the wire terninals face down towards the bottom of the door and the switch plunger face the inner door panel. You could also consider a new latch assembly W10275768 which has the switches pre mounted and aligned.

Was this helpful?

Switch, Door

Questions & Answers

Appliance Compatibility Tool

Repair Help

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information