Whirlpool 8054980 Switch, Lid - AppliancePartsPros.com

Total
$0.00

Part Number:	AP3020600
MFG Part Number:	8054980
Made by:	Whirlpool

Our Price
$32.49
Regularly	You Save
~~$38.34~~	$5.85

Most Interesting

My washer was having a hard time going into the spin cycle. We would have to turn back the timer and rerun the spin cycle usually at least 4-5 times before it would take. Sometimes it would not take at all after many attempts. I assumed this was a lid switch issue (after watching some of your you tube videos) and proceeded to order a new lid switch from your site. After placing the order, I learned how to manually activate the lid switch and watched an entire load from start to finish. I then discovered that the agitator sometimes doesn't work at all, but when it does, it barely moves back and forth (appears to be slippage). It makes a lot of noise like the motor is working, but the agitator is only moving about 2" in each direction back and forth. Please advise as to what part or parts needs to be replaced. Thank you.

Web W. for Model Number LSQ9010LG0

Answer Hello Web, You need to note whether the tub is turning while the unit should be agitating. If it is, the issue is the brake 285792 slipping. If it isn't, the clutch 285785 has failed.

Was this helpful?

Where is the switch-lid locate on kenmore washer machine model 11022972100

Bayardo for Model Number beof2@hotmail.com

Answer Hello Bayardo. You will have to remove the two screws that hold down the control panel and pivot it up out of the way. Then you should see the tabs from the switch either on the left or right side. You will have to remove the cabinet to access the lid switch. Thanks!

Was this helpful?

Wash will only go to spin cycle part of the time.

Fred B. for Model Number whirlpool LSQ9549LGO

Answer Hello Fred. You will need to check and see if the lid switch 8054980 is bad on the unit or if the lid switch strike on the lid id loose or bad. If so, it will cause the issues you are having.

Was this helpful?

Latest Questions

I have a maytag washer it spin during rinse cycle but doesnt drain.

Anthony

Answer Hello Anthony. Check and make sure the pump is no stripped out on the unit. If not, make sure the belt is good on the unit. If the pump attaches directly to the motor, you may need to replace the pump on the unit. We will need your model number to help you more with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx

Was this helpful?

Thanks for the help locating the model# lsq9110pw3. I need a lid switch replacement part for it. Thanks again

B for Model Number LSQ9110PW3

Answer Hello B. Based on the model number you provided, 8318084 is the correct lid switch.

Was this helpful?

I cannot locate any "Model#" on my whirlpool ultimate care ii washer. There is a # stamped in the back cover/metal plate it is 8318015. There is another # inside of the lid it is sm 8525079 Rev A? Neither states that it is a model #. I need a lid switch. Thanks for any help

B Clutter for Model Number Not Sure

Answer Hello B. Look under the lid around the back of the lip on the top panel of the unit with the lid raised to locate the model number. We will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx

Was this helpful?

Switch, Lid

Questions & Answers

Appliance Compatibility Tool

Repair Help

Questions & Answers

Most Interesting

Latest Questions

Cross Reference and Model Information