Hello, I want to know how to connect the control panel wires to the Switch Motor AP4042243.
Answer Hello Fredrich. You will need to locate the wiring diagram on your unit. We do not have access to this wiring diagram. However, if you locate the one on the unit, it should have the wire colors and markings listed on it.
The washer has stopped agitating and spinning. The timer, door switch and drive belt has been replaced. Now it has an electrical burning smell and hums at spin cycle but won't spin. Could the motor be bad?
You will want to check the drain pump for the bearings being bad. When you take the belt off check to make sure that the pump pulley turns freely. If not then the pump 35-6465 is bad and will need to be replaced.