Washer starts, fills and agitates fine but clicks off as soon as it hits the rinse cycle ande doesn't come back on. It does this in all 6 wash settings. Would this more likely be the lid switch or timer or something else?
You will want to check to make sure that the cold water fill screen is not clogged. If it is clogged then it will cause the unit to not fill with water. The lid switch will not allow the unit to agitate or spin if it was bad. Also check to make sure that there are no kinks or clogs in the air dome or pressure hose.
When filling washer the water does not stop I have to tur off water to the washer or it overflows.
Answer Hello Don! If you run the washer and unplug the unit does it continue to fill with water? If so, you will need to replace the water inlet valve part number 27001146. If the unit stops filling you will need to check the water pressure hose to make sure it is not kinked or clogged and replace the pressure switch part number 27001203. Hope this information helps you, thanks!