Washer would'nt wash more then light loads no matter what setting was chosen
Raymond K. • University Park, IL • September 09, 2014
Appliance: Estate Direct-Drive Washer TAWS700EQ0
My Repair & Advice
Installed the part that you sent to me (By the was, I odered the part on Friday, September 5 and FexEx delivered it at 1:00 PM on Saturday, September 6. GREAT SERVICE.) in about 5 minutes. It is a very sinple project. Unplug the power cord, turn off the water, pull off the knob. Remove two little screws the hold the control console in place and lift it up. One little screw holds the part in place which is anchored in place by an offset stem. After removing the part, take off the electical contacts, (I used a small screwdriver to pry them up from the bottom rather then pulling on them). At this point, I reattached the electrical contacts onto the new part. Then I removed the hose from the old part and reattached it to the new part. I put the part in place, reattached it with the little screw, put the knob back on, secured the control console with two little screws, plugged the power cord in, and turned on the water. I set the control to heavy load.
Worked like a charm. My wife and I did our happy dance.