Cold water selection is very very slow how ever the other selections work fine. What part do i need?
Answer Al, You probably don't need any parts. Turn off the water at the faucets, disconnect the fill hoses from the faucets and the washer fill valve.
Clean the debris and sediment from the screened washers in the end of the hoses, and the screens in the inlet valve. Flush the faucets for a minute or so, then reattach the hoses and check for a proper fill.
Please provide detailed removal and installation information for this part.
Answer Hello Michele. Disconnect the power. Then remove the knob by pulling it off the switch. Remove the back panel for the control section. Now. lift upward on the locking tab for the switch. Twist the switch and remove it from the unit. Unplug the wires going to the switch. Install new switch in reverse order.