Terminal Block

Fred V for Model Number Kenmore HE3

Answer Hello Fred, You will want to check to make sure that your motor is good. The cycle buzzer is in the main board but gets signal from the motor. Check the windings to make sure that you dont have a winding shorting out. Check from terminal 4 to ground, terminals 4 to 5 and terminals 4 to 6. 

Josh for Model Number cedx631vq1

Answer Hello Josh. You will need to check and see if the thermal fuse 3392519 or the door switch 3406105 is bad on the unit. They should read closed for continuity. You can look and see if the terminal block is burnt on the back of the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Tommie for Model Number res7646kq

Answer Hello Tommie. You will need to test the door switch 3406107 and make sure it reads closed for continuity. Also, the thermal fuse 3392519 needs to read closed for continuity. If either one of these parts are bad, the dryer will not start or run. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

David C. for Model Number kenmore dryer about 10 years old.

Answer Hello David. Yes, if the wires and the terminal block are burnt, the unit is only getting 120 volts AC and does not heat. It will run on 120 volts. You will need to replace all the burnt components and the unit should heat properly if it is getting 240 volts AC. Hope this helps. 

Mike for Model Number ler5644jt2

Answer Hi Mike. Is the dryer motor turning? If so then the belt is either broken or not attached. The belt part # is 341241. Let us know if we can assist further. Thank you.