Maytag neptune washer water will not fill code ND. New hoses and screen cleaned.
The ND error code represents that there was a no drain issue. You will want to check the drain pump to make sure that it is not clogged. Check the pressure hose to make sure that it is not clogged. Check to make sure that the units drain impeller is good and that the drain pump is working.
No hot water, good flow, clean screen. When I unplug the water valves and criss cross them, I do get hot when I push the cold selection proving that the valve works.
Am I right in assuming it's the control board?
Answer Bob, Yes, you've confirmed the hot water solenoid is in tact and operates. Assuming the control board is at fault is a good guess, but, you may want to check and verify, that the orange wire from the hot water solenoid to the P7 pin 1 connector on the control board isn't broken, damaged or loose first.
Water occasionally continues to fill the tub after a wash and I have to turn off faucets to get it to stop. Yesterday while washing, the tub overfilled and water was running out the front door. I think it is probably the water inlet valve but is there another likely cause?
Answer Bill, Yes, based on your post description and information, you will want or need to replace the water valve 22003834 The fill valve is "seaping" and allowwing the washer to fill when the valve is closed. The fill valve replacement will most likely solve both the issues you had(overfilling), if not you'll want to remove and separate the pressure switch from the drain pump assembly and check to make sure there's no debris clogging the air opening in the bottom of the pressure switch cap 22003268.