Changed igniter (broken) still no heat could thermal fuse be problem? Checked all others on burner, seems ok
Bill for Model Number GGQ8811LL0 whirl. gas dryer
Answer Hello Bill. Test and see if your getting power to the igniter 279311. Also test the thermal fuses W10423382 and flame sensor 338906. They should read closed for continuity. Check the coils 279834 and see if they test good. You can test the coils using a multi-meter TJMA-DM1. The two prong coil will read 1,000-1,300 ohms, and the three prong coil will read 1,300-1,400 ohms across prongs 1&2, and 500-600 ohms across prongs 1&3. Hope this helps.
1 person found this answer helpful.
Does the dryer have a swtch on tensioner pulley? When belt is broken dryer doesn't works.
Mike for Model Number cem2750kq1
Answer Mike,
Yes when the belt breaks the unit does have a broken belt switch 279782 that does not allow the unit to operate.
The dryer runs but the heat doesn't come on.
Isai for Model Number 11070992990
Answer Hello Isai. You will need to test the thermostats and the flame sensor and make sure they are good. They should read closed for continuity. Also, check the igniter and make sure it is getting hot enough to light the gas. Here is a link on how to use a multi-meter for the testing procedures. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html