My whirlpool quiet partner 2 is flashing the code 7. I replaced th heating element, tried a new control panel, tested the thermostat. I'm down to checking the thermister. It shows 43 ohms at room temperature. When I run under hot water the ohm reading does down steadily. From what I've read the resistance should go up under heat. With my reading going down, does this mean my thermister is bad and causing the heating error code 7?
Answer Hello Phil,
There are only 5 components in the heating circuit: the control board, the door switch, the thermistor, the heating element, and the harness. The wiring diagram should give sufficient information for troubleshooting these circuits. Be aware that resetting the clean light by doing the self-diagnostic cycle does not correct the issue and the heating element is the first suspect.
When the clean light flashes it can only mean one of two things. It can mean that the clean button is stuck and the control panel is in need of replacement or it can mean that the heating circuit has failed. The way to tell which has happened is that if the heating circuit has failed, the clean light will flash seven times with a pause and then flash seven times with a pause, etc. If the clean button is stuck there will be no pause after seven flashes. If this is the case, you need to troubleshoot the heating circuit. There are five components: the heating element, the high limit thermostat, the door switch, the control, and the wiring harness.
There should be a tech sheet behind the kick panel which will show the wiring diagram. This should enable you to shoot through the circuit with an ohm meter. If it reads open from the control board, you will need to test each component individually. It will also guide you through a self diagnostic test that is necessary to run through to clear the code so the unit can run a cycle once repaired.
The thermister you should be checking should read open until it gets up to around 145°F or so. When it reaches the high temperature it is rated for, it should open and show full contact with no resistance.