I cannot change the water temp on my Amanda front load washer. It is stuck on hot/cold cycle. What do I need to fix this problem.
Answer Hello Shirley. If the board is stuck and does not change in any cycle, you have a bad control board W10273828. This part has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part.
There is no power to the machine but power at the receptacle.
Answer Hello William. If there is power to the control board W10273828 and it does not come on, you will need to replace the board in the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
I need to replace p/n AP044724 Thermistor, in my Amana frontload washer. how do I access this part in order to do so?
Answer Hello Bill. Remove the lower front panel and locate the thermistor on the bottom of the outer tub. Then pull out the old part and press the new thermistor 34001202 into the rubber bushing. Install the wires and put the front panel back onto the unit.