Is it difficult to replace the timer?
David R. for Model Number LAT8214AAE
Answer Hello David,
It is not hard to replace the timer at all. Unplug the washer and take the screws out from across the top of the control panel. Remove the knob by popping the center out and remove the little "c" clip. Be careful not to lose it! Pull the outer part of the knob off and remove the two screws securing it to the panel. With the timer loose, you can depress the retaining clips on either side of the harness connector. Once you have removed both of the connectors, reverse the procedure to install the new timer. Reestablish the electrical connection, (plug it back in), and try the unit to insure the connections made and your done.
When my rinse cycle comes on, the water runs into the tub and and keeps draining out, and the water runs forever. If I do not turn it off. When I turn the timer back to the rinse cycle it sometimes works right.
Cindy for Model Number lat3600AAE
Answer Hello Cindy. You will need to check and make sure there is an air gap for the drain hose to breath in the unit, and that the drain hose is not to far into the drain pipe and is siphoning out. It sounds like that is the issue with the information you provided.