Dryer not getting hot, fuse bad, replaced w/ thermo kit, cleaned out long 30 ft run, also replaced vent exit. 3 to 4 weeks fuse blown again, replaced once more. Only 3 days this time, also notice can no longer use the accu-dry settings just reg. time drying. Any thoughts on this would be appreciated.
You will want to double check the venting just to make sure that there is nothing clogging it. Also check the cycling thermostat to make sure that it is good. The two smaller terminals should have voltage to them when the heating element cycles off. It sounds like the cycling thermostat may be the issue especially since the accu-dry is not working.
This dryer is not heating, I ordered a new timer installed it and still no heat . all thermostats and heating element have continuity. what else could be the problem with this thing?
Thank You for your time
If you have tested the thermostat, thermal fuse, heater and changed the timer, but the unit is still not drying then you will want to check the Terminal block to make sure that there is 240 vac getting to the terminal block. If this checks ok then the motor would most likely be the issue.