How do you get the timer off if the wires have melted on the timer and I can disconnect it from them and I do see where you sell the wire to replace them any help please on how to fix this.
Answer Hello Sebastian,
If using needle nosed pliers to get them off does not work, you may have to cut the connector off and use crimp on connectors to re-attach them. If the wiring is damaged also you will have to repair the harness since it is no longer available and it would not be a bad idea to check the circuits that connect to the timer to be checked for continuity to ground. Normally when the harness discolors and fails, it is due to a shorted component causing excessive current flow.
Is there a secret to removing the panel to replace the defrost panel?
When you look underneath the control panel there will be holes that have screws in them. When you remove the screws then you should be able to pull the panel down.