When I depress the cycle selector button nothing happens. I only hear a low buzzing sound and the dial will not stay depressed. I am not sure how many components will need to be replaced.
Answer Gene, Based on your description, you may have a low voltage problem, check and make sure there's 220 - 240 VAC at the outlet and the terminal block on the back of the dryer. As for parts needs, you'll need to consider a timer 37001240 if thats where the buzz noise is located. or blocked blower wheel or bad motor 2200376 if the buzz noise is down low in the cabinet. Hope this will help Good Luck.
1 person found this answer helpful.
My dryer does not automatically turn off in the auto modes. Is there a moisture sensor or something like that need to be replaced?
Answer Hello Eric,
There is not a moisture sensor on this unit. Based on the information it sounds like contact in timer is sticking and timer would need to be replaced.
Install a new timer and wires seem to be right. The dryer will not start but has power. Light and buzzer works.
Answer Hello Ron,
You will want to check the exhaust thermal fuse 40113801 to make sure that it is not blown. Also check your venting from the blower wheel to the outside of the home to make sure that it is clear. An obstructed vent or blower wheel will cause the thermal fuse to blow and will not allow the motor to start. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html