How do you replace the oven ignitor?
Answer Beth, "Bake Burner and Ignitor Removal 1. Turn off electrical power and gas to the range. 2. Disconnect gas and power from unit.
3. Remove oven door, racks and oven bottom. 4. Remove screws securing bottom bake cover. 5. Raise the back of the bake burner cover and slide cover back to release the front edge of cover and lift out of oven cavity. 6. Remove screws securing bake burner assembly to
the oven chassis. 7. Maneuver bake burner from the burner orifice and out of the slotted location. 8. Pull forward on assembly to allow the ignitor terminal plug to pass through the back of the oven cavity. 9. Disconnect terminal plug and remove assembly from the oven cavity.
10.Remove screws securing ignitor to bake burner. 11. Replace and reassemble in reverse order."
Serial # .10617006JL, stainless cooktop, 5 burner. I am having trouble with my front right burner not lighting correctly. It is sparking and if I blow on it sometimes it will light right up. Could you suggest the part that needs to be replaced? Also, sometimes other burners start clicking like it is trying to ignite when the burners are already lit. What is this cause? This has really been happening since it was installed!
Answer Hello Ken,
First off, all surface burners are designed to spark when any of the surface burners spark. That said, the spark module actually senses the resistance of the flame and if it thinks the flame has gone out, all surface burners should spark as per the design. Most of the time clearing the orifice with a stripped down bread tie and making certain a good ground is supplied to the burner area will take care of this issue. If ground is measured to be about the reading shown when the meter leads are touched directly together, the issue can be a failing ignitor 74009336 or ignitor wire. Worst case scenario would be a defective spark module 8286828.