How do I remove the top? I need to get to the water valve housing screws to remove.
To remove the top panel to access the water valve you will need to remove the screws in the door opening and remove the door. Once removed you will grab the front panel at the door opening and give it a little twist. This will release the front panel which you roll out and lift up. There will then be 2 screws 5/16" hex , one on either side that you will remove. Once removed then remove the bracket they were holding and this will allow you to lift the main top.
i need to know how to lift top lid to replace switch.do you lift from the front or rear. do you have to remove any parts in order to raise top cover.
Answer Bob, Raising the top of the washer is a bit involved, Remove the dispenser door and bezel on the top. Remove the loading door, and front panel, remove the two hold down clips then you can raise the top. We're sending you some additional information, that will be a great help to you. Thanks and Good Luck