How do I remove the display panel?
Answer Hello Matthew. Disconnect power. Remove the side trime from the unit. Then remove the two screws in the bottom corners of the control panel and lift off the control panel.
I replaced both the Control Board and the Touch Panel and everything seems to work except when verifying the Cavity Size of the oven which shows ID 24. How do I change that to ID 27?
BTW, the ribbon cable was the only faulty part (not the touch panel) Thanks for the help!
Answer Hello Walter. Programming the Cavity Size
When replacing the electronic control, be sure to
program the cavity size:
1. Within 60 seconds of power up, press the following
LOWER OFF, UPPER OVEN, BAKE, TEMP DOWN,
TIMER OFF, MINUTE DOWN, START, LIGHT.
2. Size is shown in display - “id 30”.
3. Press CLOCK pad until correct size is displayed.
4. Press CANCEL.
5. Press and hold LOWER OFF pad for 5 seconds to verify