The control panel went out after a power outage. The beeps, the oven light comes on. The display stays blank. I removed the transformer #9760587. I got continuity across the 2 blue terminals. I did not get continuity across the red terminals. I got another transformer and have the same problem. I still don't have continuity across the 2 red terminals. Is this transformer bad also?
The best way to test this is at the control board. You will want to check for 120 vac at the p16 connector between pins 5 and 7 for 120 vac and if there is power there then test from the p16 pins 2 to 3 for 12 to 24 vac. If there is no power at this point then transformer is bad. If there is power at this point then the control board is faulty. If there is no power at pins 5 to 7 then the control board is faulty.
Have a blank panel board have sent in for repair thought it was out. Have re-installed and still have a blank board. Checked to see if power was going to transformer put meter across both red wires and nothing. At a loss
Answer Steve, you will need to check the control panel thermal fuse 4456654 for a "closed" circuit, and voltage across connector P19 pins 1(black) and pin 3(white) for 120 VAC into the ERC/Clock and out to the transformer (120 VAC across the red wires, and 20 VAC out of the transformer to the control, across the two blue wires).