Tub Displacement Sensor

Brent for Model Number fav6800aww

Answer Brent, You will want to check the tub sensor for corrosion on the sensor connectors. This would cause the sensor to not operate properly. 

Ann Burke for Model Number Maytag washer Model MAV7200AWQ

Answer Hello Ann, The tub displacement sensor would not cause the unit to go out of balance. In the final spin you want to make sure that the unit is draining properly, make sure that the pressure switch hose is not clogged and check for uneven clothes. Check to make sure that the drain is not clogged. From the time the unit starts spin cycle the tub should be empty in approximately 90 seconds from all the water. If the unit is not draining fast enough this can cause an unbalanced load issue. 

Eugene for Model Number fav6800aww

Answer Hello Eugene! You will need harness part number 25001203 according to the model/serial numbers given. Thanks! 

Eugene for Model Number fav6800aww

Answer Hello Eugene! To determine the correct tub displacement sensor harness we will need the serial number to your appliance. Please obtain this information and repost for further assistance. Thanks! 

Doc for Model Number fav6800aww

Answer Hello Doc. Yes, the lubricant comes with the displacement sensor 12002194. 

Rich H. for Model Number FAV6800AWW

Answer Hello Rich. No, the displacement sensor 12002194 read when the tub is unbalanced. Based on the information you provided, it sounds like the clutch assembly 12002211 may be bad and will need to be replaced. Hope this helps.