Ok, but is there anything I can do about the lint? Like buy something
Answer Hello Hector! Make sure that the washer is not being overloaded and also make sure that you have the correct water temp coming into the unit. Hot water should be at 120 degrees and cold water should be above 50 degrees. Also make sure you are not using too much detergent for the load selected. Hope this helps!
1 person found this answer helpful.
Hi I am trying to replace the agitator dogs (part # 80040) in the upper agitator (part # AP4024469).
Is this possible and if so how do i disassemble the upper agitator?
Answer Hello Matt. You model does not have the type of agitator that you can replace the dogs. You would need to replace the upper agitator part# 21001878. There is a video on the part page that will show you how to do the repair.
Agitator doesn't rotate during cycle. The drum spins to drain the water but the auger doesn't spin to clean the clothes. It makes the "motor noise" as it would usually but the auger is not turning.
I checked the agitator base and it seems to be in good shape and the bolt connecting the base and the top agitator is fine and tight.
Im assuming it is the top agitator / auger piece that needs to be replaced 21001878? Thoughts?
Answer Kelly, Does the agitator base 21001530 oscillate back and forth in the wash cycle, if so then the issue will be in the upper agitator 21001878 The locking mechanism called "Dogs" has failed and isn't locking the agitator. If the agitator base doesn't oscillate in the wash cycle, then you'll need to remove the upper agitator and the agitator base and check the splines on the bottom, inside center of the base, to see if they have been " stripped" out and not grasping the splines on the agitator output shaft.