My Whirlpool washer suddenly stop working. On display it shows dl f. I call u and read repairs tips I ordered door latch. Once I replaced door latch. It shows same thing and makes same noise like cut cut, cut. What should I do.
Answer Neil, The "DL" code is an indication of a door lock issue, replacing the latch assembly is a good decision. Did you also check the wiring and connections at the new door latch and the CCU. Did you check the door hinges, front panel and door strike for proper alignment and operation, the latch can operate irratically if the strike doesn't center up in the latch opening on the door panel. If you remove the lower access panel, you should find the Tech Data Sheet over on the left side cabinet wall, and you can conduct the diagnostics and test modes, and have a better idea of what needs you'll have. Thanks and Good Luck
Washer gets to rinse and spin cycle and locks up. Timer flashes and controls lock and no error code, door also stays locked. What could be wrong?
Answer Hi Darren. The electronic control is part # 8182785 (user interface). The electronic control board is part # 8182695. Is the pump clogged and not allowing the high speed spin? Try to clear the pump. Let us know if we can assist furrther. Thank you.