User Interface

Morris G for Model Number WGO6400SWO

Answer Hello Morris. 2 parts to check here first. You will need to check the thermal fuse and the door switch. If either part is bad, the unit will not start and run. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html 

Fred S for Model Number wtw6600sw0

Answer Hello Fred. F then 53 flashes when the machine/motor control detects high temperature for the motor module. ? Does basket turn freely? If not, determine cause of friction. ? If basket turns freely, Replace the motor. 

Jeffery C for Model Number WTW6600SW2

Answer Hello Jeffery. Make sure the unit is draining and filling properly. If so, you will need to replace the main control board in the unit. 

Mike for Model Number wtw6600sw2

Answer Mike, You're on track, Yes it's true, an intermittent operation(start) issue is more likely to be a "keypad" issue than a control board problem W10070060. Replace the console/keypad assembly, and you should be fine from there on out. Good Luck and Thanks 

Penny for Model Number WTW660SW2

Answer Hello Penny. The F1 code is for: F then 1 flashes when the control detects an out of range pressure signal. ? Check pressure hose connection from tub to machine/motor control. Is hose pinched or kinked? ? If F then 1 repeats numerous times after POWER is pressed and the pressure hose connection is not pinched or kinked, replace the machine/motor control W10189966. Hope this helps. 

David B. for Model Number WTW6600SW1

Answer Hello David. If the control panel is working, but some of the buttons do not work, you will need to replace the user interface 8564290 in the unit. Make sure the door lock assembly is good on the unit. Hope this helps.