The dishes on the top rack are left dirty. Especially the ones in the corners of the rack.
We have replaced the lower inlet valve and that seemed to fix the problem for about 4 weeks. Could this be the valve inlet to the upper rack? If so, how do I get at it?
HELLO11 for Model Number Whirlpool DW GU2200XTSB-3
Answer Hello. You will need to remove the spray arms and make sure they are clear of debris. There is only one inlet valve on this unit. Also check the float and make sure it is clean, allowing enough water to come into the unit. Hope this helps.
1 person found this answer helpful.
Does not rinse.See soap bubbles at the bottom at the end of the whole cycle.What could be the problem?
Seth for Model Number GU2400XTPS6
Answer Hello Seth,
You may want to check your drain to make sure that the drain is clear and check pump for obstructions. Also you should start a cycle without anything in the unit and no detergent to see if bubbles are appearing. If this is the case you can use a little veggie oil or salt in the cycle to disperse suds. The unit may need to be run through a couple of cycles to cleanse system of excess build up of detergent. You may also need to reduce the amount of detergent being used.
Water will not fill machine. Runs through cycle with no other problems.
Frank for Model Number kuds01flwh2
Answer Hello Frank,
To check the unit for normal operation:
1. Check that the overflow protection float is free to move "up" and "down" Check that the overfill switch in opening and closing properly electrically and mechanically.
2. Check for continuity between the contacts on the fill valve.
3. Check for 120VAC between P8 and P2-3.
If further assistance is needed, please let us know.