Valve-Inlt

Dinyo for Model Number kudc03fvss2

Answer Hello Dinyo. Check and see if your getting power to the valve. If so, then the valve will need to be replaced. Hope this helps. 

1 person found this answer helpful.

James for Model Number du1055xtvs

Answer Hello James, This is most likely caused by a failing water inlet valve W10219505. Since the dishwasher fills on a time basis, if the valve doesn't open fully, it will not fill sufficiently. 

Volant for Model Number KUDS03CTBL3

Answer Volant, Yes, you're correct, there should be a resistance reading across the two terminals of the solenoid, with the wires disconnected. But in your case, you may have the resistance, but if the solenoid plunger or diaphram is "stuck" open, it wouldn't matter. Check and make sure you can hear the water level switch "click, when to raise and lower the float assembly W10077871 in the bottom of the tubIf you hear the "click", replace the fill valve W10219505. 

George for Model Number 66513839K601

Answer Hello George. If the noise is only there during the fill process, you will need to replace the water valve W10219505 on the unit. Hope this helps. 

Dinyoclese for Model Number kud03fvss2

Answer Hello Dinyoclese. Check and see if the motor impeller is broke or clogged. If so, this will cause the machine to loose pressure. Also look for debris in the sump chamber, and make sure the spray arms are not clogged. Hope this helps. 

Dinyo for Model Number kud03fvss2

Answer Hello Dinyo. Check and make sure the float switch is working properly and is not stuck on the unit. Make sure it moves freely up and down and you can hear the micro switch click. Hope this helps.