Washer shuts off and needs to be restarted between wash and rinse. I replaced timer control, but that was not it. Do not want to buy water valve if its not likely the problem. What do you think?
Answer Hello Wayne. Check and make sure the water valve screens are clear from debris. If you have hose screens check them as well. Also check the unbalanced load switches and make sure they are ok, and the wires going to them are not broken. If all of this checks good, then the valve may be the problem. Hope this helps.
1 person found this answer helpful.
Water seeps into drum when unit is off. What do you recommend?
Answer Hello Joe. You will need to order and replace the water valve on the unit.
Washer clock not advancing. Change the timer and control board switch to cold water only and not filling. Noise humming from the rear
switch to hot and cold water starts to fill. Have water to both sides. ?
could the valve be bad
Answer Hi Ray. It may be that the hot water side of the water valve is not working. The water valve is part # 22002437. Have you used the wiring diagram for assistance in hooking up the control board ? Are you sure you recieved the control board part # 22004325 ? Let us know how to assist. you in the future. Thank You.