Washer Drive Block

Phil for Model Number LSQ8000LQ1

Answer Hello Phil. It sounds like you need to order and replace the clutch assembly in the unit. 

Rick for Model Number Kenmore 110-22702-100

Answer Rick, The only thing that would determine the length of the spin cycle would be the timer. It sounds as though the timer is quick advancing during the spin cycle. With the drive block there is not a kit that has the spanner wrench and the drive block. The spanner wrench would be part number TJ90TB123A. When spinning the clutch counter clockwise it will engage the transmission and turn the motor shaft, this is for the spin. the clockwise rotation will not engage the motor shaft. This is the design in which the clockwise motion of the motor shaft is for the agitation and the transmission is what turns the agitator shaft. 

Olay for Model Number Maytag MVWC300VW

Answer Hello Olay. You will need to check and see if the suspension spring 285901 is bad and needs to be replaced on the unit. If it is broke or has come off the unit, you will need to re-install it, or replace it on the unit. 

Ben for Model Number 110.24922200

Answer Hello Ben. Check the drive block 389140 and make sure it is good and if so, you may have a bad transmission causing the issue. 

David G. for Model Number ntw4500xqo

Answer Hello David. It sounds like the nut on the top of the drive block 389140 is not tight and will need to be tightened down on the unit. 

Kristen for Model Number LSQ9549LW3

Answer Hello Kristen. No, not unless it broke and was not holding the tub assembly down in the unit. You need to check the clutch and the drive block in the unit.