HOW TO REMOVE AGITATOR?
Answer Hello Wilson. Agitator
1. Open loading door.
2. Remove fabric softener dispenser by unsnapping from
agitator. Remove agitator by one of two ways.
a. (Auger style agitators) Loosen bolt in
agitator and remove by sliding straight
up output shaft of transmission.
b. (Flex vane agitators) Remove flex vane
agitator by placing hands under agitator
lip and pull upward. If agitator is difficult
to remove, use two agitator removal
hooks, No. 254PRP under bottom edge
of agitator. Remove drive bell by pulling
upward. If drive bell is difficult to remove,
use agitator hooks. NOTE: Hooks must be positioned 180° from each other,
and must be placed under base of agitator near
agitator vane for greater stability. If hooks are
placed between the vane area, agitator damage
3. Using a rocking motion (side-to-side) carefully lift
agitator up off drive bell.
4. To reassemble place agitator on top of drive bell.
Slowly rotate agitator until fingers on underside of
agitator line up with large slots on drive bell.
5. A sharp blow on top of agitator, with the palm of your
hand, will force agitator down onto drive bell, allowing
fingers on underside of agitator to lock under bottom
edge of drive bell.
NOTE: Do not push agitator onto drive bell any further
Is there any way to retrofit a lint filter on that model washer?
Answer Hello John! Unfortunately, the manufacturer does not offer a lint filter for this model and we are unable to recommend retrofitting a filter for your product. Sorry about that!
Will this filter fit this model? It had no filter when purchased. I hang my clothes to dry so need some kind of lint filter.
Answer Hello Kathy! Unfortunately, the manufacturer does not offer a washer lint filter for your product. We can not guarantee this part will fit your unit. Sorry about that!