Water Dispenser Lever

Catherine S for Model Number ED5FHGXKQ00

Answer Hello Catherine, You may want to check to make sure that the water filter is turned in all the way. If the water filter is not in all the way you will get the hesitation and the dripping. It may also be that the water valve is not fully seating causing the water to drip. 

Note: This question is for the older version of this part, but we thought you might still find it helpful

Richard for Model Number KSRS27IHBL02

Answer Hello Richard If you haven't replaced the water filter lately, you should probably replace the water inlet valve W10408179. 

Lee for Model Number ed25pe

Answer Hello Lee. Based on the information you provided, you will need to replace the water tube assembly 4388152. 

Neal for Model Number WPL 2180268

Answer Neal, Heres some help "1. Unplug the refrigerator power cord. 2. Remove the overflow grille from the housing. 3. Unsnap front cover at the bottom of the housing. (use a flat blade screw driver, insert the blade into the slots molded into the bottom edge of the housing and pry out) 4. Disconnect the front cover switch harness connector and set the cover aside.5. Disconnect the power wire harness connector (BL/BK and W wires) 6. Disconnect the flapper door heater wire harness connector (if one is present). 7. Release the dispenser microswitch retainers and slide the switches off of their locator pins. Carefully handle the switches so they do not come apart. 8. Disconnect the wires from the terminals of the lamp holder. 9. Remove the two 1/4? hex head screws from the control bracket and remove the control bracket. 10. Remove the 1/4? hex head screw to remove the water fitting (fill spout) from the water dispenser lever. 11. Unsnap the ice guide and remove it from the ice dispenser lever.12. Remove the air pot by sliding the rear of the air pot out of the slot molded to the dispenser housing and slip the linkage out of the flapper door mechanism assembly. 13. Unsnap the flapper door and remove it from the ice dispenser lever. While you remove the flapper door, carefully guide the flapper door heater wire and connector over the door mechanism assembly. 14. Remove the 1/4? hex head screw securing the dispenser levers pivot retainer to the dispenser housing and remove the retainer. 15. Remove the water dispenser lever. 16. Remove the ice dispenser lever by maneuvering it around the door mechanism assembly.17. Pull the pin from the door mechanism assembly and remove the spring and mechanism assembly. 18. Reassemble in reverse order." Thanks and Good Luck 

Don for Model Number RS20A0XFWOO

Answer Hello Don. Based on the information you provided, it sounds like the water valve 4318046 is bad and will need to be replaced in the unit. Hope this helps. 

James T. for Model Number Model ED22CQ

Answer Hello James! Yes, the water dispenser lever in bisque is part number 2186852. Thanks!