Bill for Model Number GSS25WGSBWW I just replaced # AP3861346 Interface Display Asm Wh and it did not solve my problem. The ice maker continues to make ice as normal. When I press the push tabs the lights work but the water solenoid and auger motor will not energize. I get no drinking water or ice. The micro switch attached to the paddle has continuity and the solenoid that operates the flapper works when the paddle is pushed. I operated the auger Assy. solenoid by hand and goes up and down freely. The auger motor is not bound up. Whatever the problem is it just affects the dispenser water valve and the auger motor. This problem was intermittent at first and then just quit altogether. Thanks Bill
Answer Bill, There is a wire harness that runs out the bottom of the door. Remove the kick-plate and give each wire a tug test to make sure they are still intact. If no issues aree found there then the main control needs to be checked to see if voltage is supplied when the paddle is depressed. Test points for auger motor on main control are J7-1 [beige wire] to J7-9 orange wire. Water dispenser is J7-3 [silver wire to the same orange wire. And you are looking for 120 vac. Read More... Answered by AppliancePartsPros.com | Wednesday, April 24, 2019