Kin for Model Number WHIRLPOOL WFW8410SW02 After I replaced door bellow seal, I put everything together. I turned on the washer and the power light came on and everything was fine. I pushed the start button to start the washer, then the power turned off. I tried several times and it did the same. I took everything out to check the wiring and I did not find anything wrong. I got the power to the board and I can select any cycle and the LED light is on, but just when I push the start button the the power turns off and can't start the washer. Can you let me know the problem please? THANK YOU , Kin
Answer Kin, Remove power to the machine and remove the top panel. Check the wire harness between the CCU and the user interface, make sure the harnesses are attached and seated properly. locate the CCU, and listen closely, when you plug the power cord into the outlet, you should hear a "click" from the CCU, if not the CCU has failed. Then make a selection, and press start, you should hear the door lock activate and the door lock, if not check the lock switches and wiring. If OK, check the drain pump wiring connections and pump. Read More... Answered by AppliancePartsPros.com | Wednesday, January 3, 2018