Customer Questions and Answers for Electronic Control Board by Whirlpool

Mike, " To remove the touch-pad/LED assembly: 1. Unplug washer or disconnect power. 2. Remove the three screws on the back of the lid. Slide the lid backward and remove it. 3. To remove front console, door trim ring must first be removed. Open door and remove trim ring by pulling towards you. On Whirlpool models there are two additional locking tabs that must be unlatched first with flat bladed screw driver at the top of the trim ring. 4. Remove dispenser drawer. 5. Remove the two screws that are by the dispenser drawer. 6. On the upper side of the touch-pad/LED assembly there are 3 latches. On (WH) there are 4 latches. Unlatch them with a flat bladed screwdriver. 7. Remove the CCU. 8. Press with a flat bladed screwdriver the hook of the touch-pad/LED assembly in the hole outwardly aside. 9. Remove touch-pad/LED assembly. a) Pull the selector knob off the switch shaft. b) Press the console locking tabs, and unsnap the touchpad/LED assembly, then lift the assembly from the console and remove it."