Brad for Model Number ggw9878lwo I have a whirlpool gas dryer that is running, will not heat. I have either tested or replaced the coils, igniter, flame sensor, internal bias thermistor, the thermal fuse,and the thermal cut off kit. I have also checked to make sure there is gas and cleaned the duct system. I am not getting a glow from the igniter. What should I do next? Thank you
Answer Hello Brad. Now it is time you start tracing the voltage and see where you are loosing it at. The bad thing about this is the drum will need to be replaved and the motor running. This is the only way you are going to locate where the voltage is lost going to the timer. Everything you posted, is in the circuit, but the igniter is not glowing. You may have a bad motor or timer not sending power. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More... Answered by AppliancePartsPros.com | Saturday, March 3, 2012