Customer Questions and Answers for Direct Drive Washer Motor by Whirlpool

Edward, This would more likely be an indication of low voltage to the machine or an issue with the circuit to the machine (overloaded circuit etc...)

Buster, We would need to have the model number of your unit to be able to assist with your question but it sounds like you need to put the unit into service diagnostics and see if there are any stored error codes.

John, This 2-speed motor is a 1/3 horsepower.

Ray, Based on the information, if the motor will not move when power is applied to it and it is not connected to the gearcase or the pump then the motor would certainly be the issue.

Chuck, Has the washer shown any sign of failure? All you can do is visually check under the console and the harness going to the motor at this point for wire insulation melting or dark spots on connectors. Makes sure all harnesses are plugged in tight with a good connection. A loose connection causes heat by itself.

Michael, the part that is leaking is going to be the start capacitor WP8572720 and will need to be replaced. The start capacitor can cause this issue and would be the first step necessary.

Hello Handywilliams, code 6 refers to a locked rotor, meaning something is preventing the motor/belt/pulley,mode/shifter/agitator or basket from turning. The 7 code refers to the lid switch, not opening/closing correctly.

Hello Emil, unfortunately, we cannot advise on modifying the wiring to a part such as this for a different application other then what the manufacturer intended,the motor is controlled by a timer and also needs a capacitor to work correctly.

Jason, the motor WP661600 is a direct replacement part listed by the manufacturer as replacing both 3951550 and 8528158. As such, incorporating the slow run winding may not occur with your model. If you could provide the model number for your appliance in a new inquiry, this will allow for the most accurate information to be presented.

Hello James, motor part number WP661600 does not include a new capacitor. We will need the model number in order to locate the correct start capacitor for your unit, thanks!