Black & Decker Parts

This is a replacement line trimmer bump cap found on several models of trimmers. This bump cap is used to hold the spool and bumper in the spool housing. It provides some protection to the line spool. If this piece is damaged or broken, it will not keep the line spool safe and in place.The bump cap is made from durable plastic. However, it still can break or start to wear down. Parts of it could crack and chip. Check the bump cap occasionally and replace it if it is showing signs of damage. The replacement is easy. The old cap can be removed by pressing on the two tabs, and then a new one can be added. The replacement should take a matter of minutes.This bump cap is compatible with certain models of trimmers from Black & Decker and DeWalt. The cap is sold individually. It is a genuine OEM replacement product.

This fresh food door gasket creates the airtight seal between the refrigerator door and cabinet. Replacing a worn gasket restores proper sealing to keep cold air in, reduce moisture, and stabilize internal temperatures.

• Seals the fresh food compartment door to maintain cooling efficiency
• Helps prevent warm air leaks that cause condensation, frost, or extended run times
• Replaces gaskets that are torn, warped, cracked, or won't lie flat
• Signs of failure include visible gaps, moisture on the liner, doors not closing smoothly, or rising fridge temps

• Disconnect power before servicing
• Let the gasket warm to room temperature; use low heat or warm water to relax waves
• Pull the old gasket from its channel; on some models, loosen inner liner screws to remove/seat the gasket
• Press the new gasket fully into the groove starting at the corners; adjust door alignment if needed

Here is a replacement shoulder bag used for leaf blowers/vacuums. The shoulder bag makes it easy for users to have a place to quickly and easily collect all of the leaves and other debris that has been sucked up by the vacuum. When the bag is full, the user can simply remove it from their shoulder and empty it into the appropriate bin. It makes it easier to clean up the yard and can eliminate the need for raking. While these types of bags seem durable, they can start to wear down over time. Whether the shoulder strap is breaking or there are holes in the bag, it's best to replace it sooner rather than later. Otherwise, it could break while it is being used, which would cause a mess. There is no real replacement procedure since this is just a shoulder bag that is used in conjunction with the blower/vacuum. The shoulder bag is a genuine OEM replacement, which is sold individually and is compatible with leaf blowers/vacuums from Black & Decker and DeWalt.

This replacement part is a screw. It is a fastening component which secures other parts within the equipment.If the screw has become stripped, it might be unable to hold other parts in place. If the part is lodged in place and is unable to perform the appropriate action, it should be replaced as soon as possible. This is a genuine replacement part made by Dewalt. It is an OEM replacement part which will ensure a proper fit. This part is sold individually.

This is a lever for string trimmers. This particular lever is used to control the amount of line that is fed from the auto-feed spool on the trimmer. This part has a tendency to wear out due to normal wear and tear. It's always a good idea to have an extra one on hand because of this. This part can easily come into physical impact with hard objects while trimming. The black plastic material that it is made out of can crack and break if the force is excessive. If this happens, it will need to be replaced. The operator should never place his or her hands near this component while the machine is operating.This component is an OEM part sourced directly from the manufacturer. It is sold individually. This specific lever is compatible with electric string trimmers that are manufactured by Black + Decker.