After finding out that I could not lift the top of the stove up without taking of both sides and part of the back covers. I chased the wires for the burner to the controls, cut them both off at the burner and exposed about 3/4" of wire. wrapped the two wires together and used the supplied ceramic wire nuts to connect the new terminal block to the stove.Attached the block to the lip of the burner hole like the old one. After reattaching the 220V plug to the wall I turned on the burner unit. It worked just fine. Reassembled the back panel, cleaned behind the stove and pushed it back into place. Replaced a burned out florescent light tube that I did not know was there and now she has light and a working stove. Thanks for your speedy delivery!